Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio » Radio Mods » Icom IC02 PL Out of Band Modification
Icom IC02 PL Out of Band Modification [message #62] Sun, 25 June 2006 16:36
root is currently offline  root
Messages: 207
Registered: December 2004
Senior Member
The following method of modifying the Icom IC02. This one should give you PL out of band without jumpering 5 VDC to the tone chip. Use 1N914 or equivelent when adding diodes.

1. On the logic matrix, remove D402 and D403.

2. Add D402, D403 and D404 with the cathode at 4 o'clock and the anode at 12 o'clock.

3. Retune the VCO to cover your desired frequency spread. My 02AT did not want to go beyond 163 MHz. I have a friend whowas able to get his to the low 170s.

4. To jump from 140 to 150 or from 150 to 160 (or vice versa) you must "tune across" the boundry, in the same way that you do for an unmodified 02AT. For example, key in 149.995 and then move up until you are in the 150s. You can then enter any 150 MHz frequency (starting with the MHz).

-----------------------------


***->Be careful not to transmit out-of-band, or accidentally operate on any non-amateur, unless you are authorized to do so.

DO NOT JEOPARDIZE YOUR LICENSE!
Previous Topic: Expanding Functions for the IC-V8000
Next Topic: Audio Modification for Icom IC02 and IC04 Radios
Goto Forum:
  


Current Time: Sat Nov 25 06:27:40 EST 2017

Total time taken to generate the page: 0.03468 seconds