Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio » Radio Mods » Alinco DJ-160 Mods
Alinco DJ-160 Mods [message #51] Fri, 28 April 2006 22:55
root is currently offline  root
Messages: 207
Registered: December 2004
Senior Member
The new Alinco DJ-160 Radio will receive between 137-174 Mhz, and transmit in the 2Meter band only (144-148Mhz). A simple modification to the radio will enable it to transmit in the full range it receives currently. I have not tested the output power on other frequencies (Due to my one and only watt meter getting fried)however I have tried setting a weather receiver a small distance away, and I did hear the radio in the receiver. To make the mod, the following must be done: (I bassume that you have some experience with electronics and that you can tell a wire from a resistor, from a transistor)

1) Take the battery of the radio by lifting the battery release button. If you look at the bottom of the radio, there will be a metal plate that is held on with 4 small screws. Take this plate off, noting exactly how the clip was held on (like the slot for the battery release clip)

2) On the back of the radio there are two screws that hold the back of the radio on, take these screws out.

3) Now you should be able to lift the bottom part of the radio by the battery release button slightly apart. I was told that you should take the top knobs off, but I found that I didn't have to.

4) If you take the Battery Release Button and turn it about 90 degress, the button should come out easily. After you get the small piece of plastic that is the button, you should see a yellow wire behind where the clip was.

5) Take a small wire cutter and CUT this YELLOW wire. You should probably make sure that the wire doesn't have bare metal showing from a lousy cutter, because I don't think that grounding this wire to the case would be HEALTHY for your radio. Smile

6) After You cut this wire. bassemble the radio, and just before you turn on the radio, do a power reset by holding the FUNC button while turning on the radio. This will reset the radio to ALL of the factory set parameters. YOU WILL LOOSE PROGRAMMED FREQUENCIES that were programmed into the memory mode of the radio, so just write the frequencies down before proceding with the above instructions.

7) The radio should be just like new, except that the transmit will be enabled for ALL frequencies! GOOD Luck!
Previous Topic: Kenwood TM-2550 Mars/Cap
Next Topic: Cherokee AH-50 HT Mods
Goto Forum:
  


Current Time: Sat Nov 25 00:44:16 EST 2017

Total time taken to generate the page: 0.03395 seconds