Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio Mods » Icom Mods » ICOM IC-32AT Elimination of faint pulse noise (ICOM IC-32AT Elimination of faint pulse noise)
ICOM IC-32AT Elimination of faint pulse noise [message #3076] Sun, 08 March 2015 22:26
root is currently offline  root
Messages: 207
Registered: December 2004
Senior Member
 Model:         IC-32AT

 Division:      Amateur

 Note:          This service bulletin is meant for technical per-
                sonnel with experience working on solid state com-
                munications equipment.  Damage caused by im-
                properly installing this modification may cause
                ICOM to charge for subsequent repairs to the
                product.  ICOM does not warrant this modification.

 Bulletin #:    13889-004

 Date:          May 1, 1989

 Subject:       Elimination of possible faint pulse noise from
                speaker when radio is in power save mode

 Information:   The power save mode employs a circuit which
                creates a high level square wave signal used in
                the power save function.  This modification alters
                the square wave characteristic to eliminate the
                noise.

Procedure

    1. Remove the covers from the radio and locate the main board.
    2. Locate C-749 and replace it with a 2.2 uf 16 V tantalum chip capacitor.
    3. Reassemble the radio, power up and allow the unit to enter the power save mode.
    4. Check to see that the pulse type noise has been eliminated.
    5. Replace the covers and return the radio to service. 
Previous Topic: ICOM IC-32AT Out of Band Mod
Next Topic: ICOM IC-32AT Hidden Features Mod
Goto Forum:
  


Current Time: Sat Nov 25 02:32:02 EST 2017

Total time taken to generate the page: 0.03628 seconds