Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio Mods » Icom Mods » ICOM IC-735 Add Remote Control (ICOM IC-735 Add Remote Control )
ICOM IC-735 Add Remote Control [message #3073] Sat, 07 March 2015 22:46
root is currently offline  root
Messages: 207
Registered: December 2004
Senior Member
I have finally got the remote control working on the IC735. The interface is home-made and uses just 2 transistors, 1 diode, 5 resistors, DB25 and a DB15(to get 5v from games port). The software is a major re-hash of VK7TM's FT757 effort in ARA. All functions are driven from the XT keyboard and the software allows scanning of a LARGE number of frequencies on the same or on different bands.

The trials and tribulations of all this effort were NOT assisted in any way by the manufacturers local office in Melbourne. A call for information was not very successful. (try it and see!) If you are contemplating the idea of turning your IC735 into a multi-channel HF scanner, I may be contacted @ VK3YZW BBS.. The software is suitable for use with XT/AT Clone... Available control functions:
Send a new frequency to the radio from the keyboard.
Send a new Mode to the radio.
Select VFO A or VFO B.
Select a different memory channel
Enable the selected memory channel
Write current Freq/Mode to selected memory channel.
Write current Freq/Mode to last used VFO.
Read/Edit/Use a frequency file from Disk.
SCAN frequencies in a frequency file.
The frequency files contain frequency/mode/description of station all of which is displayed on the screen when the file is active.

[Updated on: Sat, 07 March 2015 22:47]

Report message to a moderator

Previous Topic: ICOM IC-735 TX Mod
Next Topic: ICOM IC-735 RS232 Interface to meet RS232 Specs
Goto Forum:
  


Current Time: Fri Nov 17 12:42:04 EST 2017

Total time taken to generate the page: 0.03301 seconds