Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio Mods » Icom Mods » ICOM IC-746 Out of Range TX/RX Mod (ICOM IC-746 Out of Range TX/RX Mod)
ICOM IC-746 Out of Range TX/RX Mod [message #3067] Tue, 03 March 2015 21:44
root is currently offline  root
Messages: 208
Registered: December 2004
Senior Member
In IC746DW.JPG you can see the open bottom side from the transceiver and you will see a red marked area, too.

This marked area you can see again and bigger in the picture below.

Now something about this image.

There are some green frames. This are diodes which must be on this place. There are some red frames. Thess are diodes which you have to remove. Where no frame is, there is no diode in my transceiver.

After removing the red marked diodes you should can RX 60 khz - 60 MHz and 118 Mhz - 176 MHz TX 100 khz - 60 MHz and 118 Mhz - 176 MHz

[Updated on: Tue, 03 March 2015 21:50]

Report message to a moderator

Previous Topic: ICOM IC-756 ACC1 Audio Output Increase Mod
Next Topic: ICOM IC-746 TX/RX Frequency Mod
Goto Forum:

Current Time: Fri Nov 16 09:01:09 EST 2018

Total time taken to generate the page: 0.04227 seconds