Ham Radio
Ham Radio, Electronics, Software and more...

Home » Computers » Hardware » FGPA Ham Radio Controller for ICOM (FGPA Ham Radio Controller for ICOM)
FGPA Ham Radio Controller for ICOM [message #3052] Thu, 01 January 2015 11:51
root is currently offline  root
Messages: 208
Registered: December 2004
Senior Member
Icom's PCR-1000 radio has a 9 pin serial interface for the controller. Usually this is done through a PC and software. Since the industry is going towards microcontrollers and FPGAs, I decided to make a simple controller with an FPGA to see if it was possible. The software that ICOM has is limited to what they offer. It is not open source, so modifying the software to do what you want is impossible. Watch the video for the implementation on an FPGA:


Next Topic: Fixed: A disk read error occurred. Press Ctrl+Alt+Del to restart
Goto Forum:

Current Time: Mon Nov 19 10:55:05 EST 2018

Total time taken to generate the page: 0.04754 seconds