Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio Mods » Alinco Mods » Alinco DJ-162 Mod Extended RX/TX (Alinco DJ-162 Mod Extended RX/TX)
Alinco DJ-162 Mod Extended RX/TX [message #2997] Sat, 06 July 2013 01:09
root is currently offline  root
Messages: 207
Registered: December 2004
Senior Member
Extended RX/TX for Alinco DJ-162

1. Remove the battery pack. Remove the battery plate from the bottom of the radio.
2. Remove the back cover from the radio. This is a tedious process. You must take the knobs off the top and remove the top plate first.
3. Under the Battery clasp on the side of the radio (The little sliding thumb switch that keeps the battery from falling off the radio) you will find a yellow loop of wire. This loop is small and hard to get to. You will need a very small pair of cutters or scissors.

--Cut this wire.

4. Put the radio back together

5. Reset the radio. (You will lose your memories)

6. Go to the VFO mode.
Pressing the 'B' key on the keypad will now allow
you to cycle through the extended rx bands. It will cycle from 2 mtrs, am aircraft, to 800. The radio does NOT have the guts to receive 800. It just happens to be in the processor so don't waste your time listening.

7. This same jumper also opens extended transmit.

Ron Wright - KA5LUG
Previous Topic: Alinco DJ-160 Mod Extend TX
Next Topic: ALINCO DMR610 DR-135 DR-435 Microphone Wiring Pinout
Goto Forum:
  


Current Time: Sat Nov 25 06:31:21 EST 2017

Total time taken to generate the page: 0.03947 seconds