Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio » Programming Radios » motorola cm140
motorola cm140 [message #165] Sun, 20 April 2008 16:03 Go to next message
bciprian82 is currently offline  bciprian82
Messages: 1
Registered: April 2008
Location: romania
Junior Member

can anyone help me finding the programming software and the interface for a motorola cm140 radio? thanks
Motorola CM-140 programming Cable [message #315 is a reply to message #165] Thu, 10 March 2011 02:49 Go to previous message
root is currently offline  root
Messages: 207
Registered: December 2004
Senior Member
Motorola mobile CM series radios are programmed through the rear accessory connector. The programming cable is not powered from the port. The power supply can be taken from the radio power supply or the accessory connector if available.



The cables should be shielded for radios with RRxD and RTxD connections. Multi-wire cable with low mutual capacitance among wires is also applicable. Otherwise TxD to RxD interference may result in programming failure. It is important for some Kenwood radios.

The recommended programming software is R05.00, R05.00.02, R05.04.

[Updated on: Thu, 10 March 2011 03:05]

Report message to a moderator

Previous Topic: Kenwood KPG-4 Cable Schematics
Next Topic: Motorola mcs2000
Goto Forum:
  


Current Time: Sat Nov 25 06:19:51 EST 2017

Total time taken to generate the page: 0.03433 seconds