Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio » Radio Mods » Uniden BD996 Discriminator tap
Uniden BD996 Discriminator tap [message #161] Sun, 03 February 2008 13:03
root is currently offline  root
Messages: 207
Registered: December 2004
Senior Member

Uniden BD996 Discriminator tap


OK, I dug around a little and it appears our friends at Uniden made it real easy!

Take off the outer case shell, and then the top inner case. Just about dead center on the board look for the solder pad labeled "DISC". Run a single insulated wire to this point to a jack of your choice (I prefer RCA jacks) mounted on the rear of the radio. I also like to use a tantalum capacitor in line with the jack as well.

If you take the bottom inner cover off the radio you will see the best place to install the jack appears to be the area of the bar code/serial number label. This is kind of thick double walled metal so be careful drilling. You could also just run an audio cable into the radio through the threaded rear hole or even one of the holes on either side of the radio's rear.

Ray Colvill

[Updated on: Sun, 03 February 2008 13:05]

Report message to a moderator

Previous Topic: Expand Frequency Coverage on TX/RX for the Icom IC-W32A/E
Next Topic: Kenwood Mic to Icom Radio Conversion
Goto Forum:
  


Current Time: Sat Nov 25 06:17:06 EST 2017

Total time taken to generate the page: 0.03456 seconds