Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio » Radio Mods » Programming Cable for Icom IC-F12
Programming Cable for Icom IC-F12 [message #136] Sat, 02 June 2007 01:36
root is currently offline  root
Messages: 207
Registered: December 2004
Senior Member

Programming Cable for Icom IC-F12

Simple handle programmer for radio transceiver ICOM ICF12, mounted with one plug P2 stereo and a female connector DB25 where bolt 15 of the female DB25 will be for data, bolt 1 land. It will have to be made to jumper between bolts 4 and 11 of the female DB25, this female connector DB25 will go on in any interface on type RIB to a PC. Detail of plug P2 stereo that will go to the radio:

bolt 1 nc
bolt 2 data from bolt 15 female DB25
bolt 3 gnd from bolt 1 female DB25

[Updated on: Sat, 02 June 2007 01:38]

Report message to a moderator

Previous Topic: IC-P7A MARS Mods
Next Topic: Add 30-meter Transmit to Kenwood TS-180S Transceiver Mod
Goto Forum:
  


Current Time: Wed Nov 22 19:06:31 EST 2017

Total time taken to generate the page: 0.03695 seconds