Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio Mods » Alinco Mods » Alinco DR-110 Full Band Mod (Alinco DR-110 Full Band Mod)
Alinco DR-110 Full Band Mod [message #3097] Wed, 29 April 2015 01:04
root is currently offline  root
Messages: 208
Registered: December 2004
Senior Member
Alinco DR-110 Full Band Mod

tep 1. Remove 2 screws located on top of cover.
Step 2. Loosen the 4 screws on both sides of top cover (do not remove).
Step 3. Remove top cover
Step 4. Locate Yellow wire Loop behind tuning Knob (this wire loops from
the control board mounted on front pannel).
Step 5. Cut loop and tape ends.
Step 6. Replace top cover.
Step 7. Reset radio (press 'F' and VCO/M keys together. While holding
down keys turn off and on Power).

Factory settings will be restored however the new frequency range will
be from 132 to 173 MHz. Any memory will have to be reprogramed.
These insructions are from Alinco, I've done them to my set and
it works great.

This modification also works on the DR1200T and DR112 radios. Frequency range
when applied:

130.000 - 169.995
340.000 - 379.995
870.000 - 889.995
Previous Topic: Alinco DJ-580T Air and Out of Band Mod
Next Topic: Alinco DR1200T Full Band Mod
Goto Forum:

Current Time: Sun Sep 20 13:11:14 EDT 2020

Total time taken to generate the page: 0.02906 seconds