Ham Radio
Ham Radio, Electronics, Software and more...

Home » Ham Radio Mods » Alinco Mods » Alinco DJ-580T Air and Out of Band Mod (Alinco DJ-580T Air and Out of Band Mod)
Alinco DJ-580T Air and Out of Band Mod [message #3096] Wed, 29 April 2015 01:00
root is currently offline  root
Messages: 208
Registered: December 2004
Senior Member
Alinco DJ-580T Air and Out of Band Mod

This is a very simple mod it will give you aircraft band RX,
from 108-130 Mhz AM. On the first part and RX/TX from 130Mhz-
170Mhz on VHF and 415 - 470 Mhz on UHF (Approximate).

1. Remove the battery from the radio.
2. Look at the bottom of the radio where the battery mounts.
3. Locate four screws that hold the battery mounting plate to the
bottom of the radio. Remove these four screws.
(Be careful, the screws are SMALL!)
4. The battery plate is still attached by two wires but there should
be enough slack in them to get around the plate with a pair of
5. With the radio's keypad and display facing up, locate a loop of
red wire on the right side of the radio interior.
6. Cut this wire for AM Aircraft band RX.
7. On the left side of the interior, locate a loop of blue wire.
8. Cut this wire for TX/RX as described above.
9. Insulate the exposed ends of these wires so they do not short.
10.Re-attach the battery mounting plate and replace the battery.
11.With the radio off, hold down the function key and turn the
radio on.

Previous Topic: Alinco DR-430 Extend Transmit Mod
Next Topic: Alinco DR-110 Full Band Mod
Goto Forum:

Current Time: Mon Dec 10 03:42:07 EST 2018

Total time taken to generate the page: 0.04604 seconds